Dell PowerConnect W-IAP3WN Dell Instant 6.1.3.1-3.0.0.0 Mobility Starter Kit Q - Page 7

Dell Networking Mobility Starter Kit - Quick Setup Guide 3. The Setup Wizard is run automatically .The Setup Wizard displays the following information: Welcome to Dell Easy Setup Wizard The Setup Wizard guides you through the initial switch configuration and gets you up and running easily and quickly. You can skip the Setup Wizard and enter CLI mode to manually configure the switch. The system will prompt you with a default answer; by pressing Enter, you accept the default value. You must respond to the next question to run the Setup Wizard within 60 seconds, otherwise the system will continue with normal operation using the default system configuration. Would you like to enter the Setup Wizard (you must answer this question within 60 seconds)? (Y/N) 4. Enter [Y] to run the wizard. After entering [Y] the wizard provides interactive guidance through the initial switch configuration. The following information is displayed: You can exit the Setup Wizard at any time by entering [ctrl+Z]. The system is not set up for SNMP management by default. If you enter [N] or if you do not respond within 60 seconds, the Setup Wizard automatically exits and the CLI console prompt is displayed. To manage the switch using SNMP (optional, required for OMNM) you can: • Setup the initial SNMP version 2 account now. • Return later and setup the SNMP version account. For more information on setting up an SNMP version 2 account, see the Dell PowerConnect 5500 Series User Guide and Getting Started Guide at support.dell.com/manuals. Would you like to set up the SNMP management interface now? [Y/N] NOTE: If you are not setting up OMNM at this time and cannot obtain the SNMP information in steps 6 and 7, enter [N] to skip to step 8. It is recommended to setup SNMP within this Setup Wizard if you intend on using OMNM. 5. Enter [N] to skip to Step 8 or enter [Y] to continue the Setup Wizard. If you enter [Y] the following information is displayed: To set up the SNMP management account you must specify the management system IP address and the "community string" or password that the particular management system uses to access the switch. The wizard automatically assigns the highest access level [Privilege Level 15] to this account. You can use Dell Network Manager or other management interfaces to change this setting later and to add additional management system later. For more information on adding management systems, see the user documentation. 7