Dell PowerEdge 2650 2-Post Rack Installation - Page 11
Install the stiffening bracket into the appropriate holes at the back of the slide
View all Dell PowerEdge 2650 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Center-Mount Installation The two-post rack kit is shipped with the brackets configured for center-mount installation. To complete the installation, perform the following steps: 1 Locate the right slide assembly and push the back bracket toward the back of the slide assembly (see Figure 1-4). 2 Position the right slide assembly in the two-post rack at the location you marked, push the back bracket forward against the vertical two-post rack, secure the front centermounting bracket with two 12-24 x 0.5-inch pan-head Phillips screws, and secure the back center-mounting bracket to the rack with three 12-24 x 0.5-inch pan-head Phillips screws (see Figure 1-4). 3 Repeat steps 1 and 2 to install the left slide assembly in the rack. 4 Install the stiffening bracket into the appropriate holes at the back of the slide assemblies and secure the bracket with a 12-24 0.5-inch pan-head Phillips screw on each slide assembly (see Figure 1-4). If the vertical rack is 3 inches wide, use the holes at the back end of the slide assemblies (shown in Figure 1-4). If the vertical rack is 6 inches wide, use the holes located 3 inches in front of the holes at the back end of the slide assemblies. 2-Post Rack Installation 1-7