Dell Unity XT 480 WEEE Li-Ion SPS Disassembly Instructions - Page 20

12.0 Disassembling the Li Ion SPS The following sections describe how to remove the components and associated materials. 12.1 Prerequisites Gather the required tools and familiarize yourself with the safety precautions before commencing disassembly. 12.1.1 Required Tools for Disassembly Table 14 lists the tools that may be required to disassemble the product. Table 14 Tools Tool Phillips screwdriver Phillips screwdriver Flat-head screwdriver T10 Torx driver Needle-nose pliers Wire Cutters Soldering Iron Description small medium medium T10 Torx driver required for battery-pack disassembly Use to remove precise hardware from PCBs. Use to remove capacitors, or cut wires. Use to unsolder the leads that attach some components to a PCB. 12.1.2 Safety Precautions and Battery Warnings Comply with the following precautions: • Wear protective glasses during disassembly. • Follow the recommended disassembly method and sequence. • Always use the tool specified in the removal procedures. • Follow standard industry best practices, including all applicable health and safety regulations. Battery Warnings: • Only trained personnel should handle the battery. • Danger of explosion if battery is incorrectly replaced. • Danger of explosion if system batteries or components with batteries are processed in a shredder. • Discard used batteries according to manufacturer's instructions. • Do not attempt to reuse or install batteries in any other system, for any other purpose. • The Lithium-ion batteries within the battery-pack may cause chemical hazards and present an energy hazard if mishandled. See MSDS if necessary. • Do NOT transport used battery-pack by AIR. WEEE Disassembly Instructions for the Li Ion (SPS), doc #302-000-589 20