Dell Unity XT 480 WEEE Li-Ion SPS Disassembly Instructions - Page 28
Using a sharp tool, cut the battery tray in small s and then separate the tray from
View all Dell Unity XT 480 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
12. Using a soldering iron or similar tool, remove the solder in the 13 places shown below and then detach the PCB from the battery assembly. Figure 24. Solder locations where PCB is secured to battery assembly The 48 Lithium-ion batteries are sandwiched between two plastic trays that are both welded and glued to the assembly. The best way to remove the plastic battery trays is to remove it in sections by cutting it between the batteries as shown below (double yellow-dashed lines). 13. Using a sharp tool, cut the battery tray in small sections and then separate the tray from the batteries. Do this for both trays and all the batteries. Note: Be careful not to cut or damage the Lithium-ion batteries during this process. If necessary, review the MSDS for these batteries before proceeding. Figure 25. Cut locations to remove battery trays WEEE Disassembly Instructions for the Li Ion (SPS), doc #302-000-589 28