Dell Unity XT 480 WEEE Li-Ion SPS Disassembly Instructions - Page 34
Using a flathead screwdriver, remove the four 4 screws that secure the PCB to
View all Dell Unity XT 480 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
13. Using a Philips screwdriver, remove the two (2) screws that secure the plastic midplane baffle and then slide the baffle upward and out of the chassis. Figure 38. Removing the midplane baffle 14. Remove the midplane connector PCB by doing the following: a. Disconnect the ribbon cable from the midplane connector PCB. b. Remove the nuts securing the power cables and detach the cables from the PCB. c. Using a flathead screwdriver, remove the four (4) screws that secure the PCB to the midplane chassis. d. Detach the PCB from the chassis. b c c a c c b Figure 39. Removing the midplane connector PCB WEEE Disassembly Instructions for the Li Ion (SPS), doc #302-000-589 34
34
WEEE Disassembly Instructions for the Li Ion (SPS), doc #302-000-589
13.
Using a Philips screwdriver, remove the two (2) screws that secure the plastic midplane baffle
and then slide the baffle upward and out of the chassis.
Figure 38. Removing the midplane baffle
14.
Remove the midplane connector PCB by doing the following:
a.
Disconnect the ribbon cable from the midplane connector PCB.
b.
Remove the nuts securing the power cables and detach the cables from the PCB.
c.
Using a flathead screwdriver, remove the four (4) screws that secure the PCB to the
midplane chassis.
d.
Detach the PCB from the chassis.
Figure 39. Removing the midplane connector PCB
a
b
b
c
c
c
c