Dell Unity XT 480 WEEE Li-Ion SPS Disassembly Instructions - Page 31
Using a small Philips screwdriver, remove the fastener that secures the multi-colored plastic
View all Dell Unity XT 480 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
5. Remove the plastic parts by doing the following: a. Using a flathead screwdriver, remove the fastener that secures the plastic latch mechanism and then remove that part. b. Using a small Philips screwdriver, remove the fastener that secures the multi-colored plastic wheel and then remove that part. Figure 32. Disassembling the latch mechanism 6. Using a Philips screwdriver, remove the six (6) fasteners that secure the rear panel to the SPS chassis. (2 on each side and 2 on bottom) Figure 33. Location of 4 of 6 rear panel fasteners (2 fasteners on unseen side) WEEE Disassembly Instructions for the Li Ion (SPS), doc #302-000-589 31
31
WEEE Disassembly Instructions for the Li Ion (SPS), doc #302-000-589
5.
Remove the plastic parts by doing the following:
a.
Using a flathead screwdriver, remove the fastener that secures the plastic latch mechanism
and then remove that part.
b.
Using a small Philips screwdriver, remove the fastener that secures the multi-colored plastic
wheel and then remove that part.
Figure 32. Disassembling the latch mechanism
6.
Using a Philips screwdriver, remove the six (6) fasteners that secure the rear panel to the SPS
chassis. (2 on each side and 2 on bottom)
Figure 33. Location of 4 of 6 rear panel fasteners (2 fasteners on unseen side)