Dell W5300 Workgroup Laser Printer Dell™ Workgroup Laser Printer W53 - Page 138

Queuing Jobs Ready The printer is sending one or more held jobs to print. The printer is ready to receive and process print jobs. Wait for the message to clear. See also: Using the Print and Hold function Send a job to print. Ready Hex Reattach Remove Paper The printer is in Hex Trace mode and is ready to receive and process print jobs. The envelope feeder is either not fully connected to the printer or is experiencing a hardware failure. Send a job to print. All data sent to the printer is printed in hexadecimal and character representation. Control strings are printed, not executed. Turn the printer off and then on to exit Hex Trace mode and return to Ready status. Reestablish communication by removing the envelope feeder and reattaching it to the printer. Press Go to clear the message and continue printing without using the envelope feeder. In the case of a hardware failure, turn the printer off and back on. If the error recurs, turn the printer off, remove the envelope feeder, and call Dell at support.dell.com. The output bin is full. See also: Contacting service Remove the stack of paper from the standard bin to clear the message. Res Reduced Resetting Maint Cnt Value The printer is reducing the resolution of a page in the current job from 600 dots per inch (dpi) to 300 dpi to prevent a 38 Memory Full error. Res Reduced remains on the display while the job prints. Press Menu to open the Job Menu and cancel the current job. The printer is resetting the counter that tracks wear on the fuser. Wait for the message to clear. Resetting the Printer The printer is resetting to the current default settings. Any active print jobs are canceled. Wait for the message to clear. See also: Using the operator panel to change printer settings The printer is restoring the Wait for the message to clear.