Denon 3808CI Owners Manual - Page 30
Error Messages, Option, Parameter Check - reset
UPC - 081757507646
View all Denon 3808CI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
Getting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting Error Messages If the auto setup procedure could not be completed due to speaker installation, the measuring environment, etc., an error message is displayed. If this happens, check the relevant items, be sure to take the necessary measures, then perform the auto setup procedure over again. Error messages (examples) Cause Measures No microphone or speaker • Included setup microphone is not connected. • Not all speakers could be detected. • Connect the included setup microphone to the SETUP MIC jack on the main unit. • Check the speaker connections. Ambient noise is too high • Too much noise in the room for accurate • Either turn off any device generating noise or move it or Level is too low measurements to be made. away. • Try again when the surroundings are quieter. • Speaker or subwoofer sound is too low for • Check the speaker installation and the direction in which accurate measurements to be made. the speakers are facing. • Adjust the subwoofer's volume. None • Displayed speaker could not be detected. • Check the connections of the displayed speaker. · The front L and front R speakers were not properly detected. · Only one channel of the surround (A) and surround (B) speakers was detected. · Sound was output from the R channel when only one surround back speaker was connected. · The surround back or the surround (B) speaker was detected, but the surround (A) speaker was not detected. Phase • Displayed speaker connected with the polarities • Check the polarities of the displayed speaker. reversed. • For some speakers, this error message may be displayed even if the speaker is properly connected. If you are sure that the wiring is correct, select "Skip". Select "Retry" to make the measurements again. NOTE Be sure to turn the power off before checking the speaker connections. s Option Select settings for room EQ, mic, etc. Room EQ Select room EQ setting method. [Selectable items] All Assign Direct Mode Select room EQ use for DIRECT or PURE DIRECT mode. [Selectable items] ON OFF Mic Select Select the microphone type if not using supplied mic. The microphone connected to V.AUX Lch is used. [Selectable items] Mic V.AUX L Only a professionally certified installer should ever connect a professionally-calibrated microphone to the V.AUX L input on the front panel. d Parameter Check Check auto setup measurement results. This is displayed after the auto setup procedure is completed. [Items to be checked] Spkr Config Check Distance Check Ch. Level Check Crossover Check EQ Check The auto setup results can be reset to what was originally calculated by MultEQ XT when "Restore" is selected.