Denon AVR-1312 Owners Manual - Page 60

Basic version Advanced version Resetting the microprocessor Perform this procedure if the display is abnormal or if operations cannot be performed. When the microprocessor is reset, all the settings are reset to their default values. ON/STANDBY 1 Turn off the power using ON/STANDBY. 2 Press ON/STANDBY while simultaneously pressing 8 and 9. 3 Once the display starts flashing at intervals of about 1 second, release the two buttons. If in step 3 the display does not flash at intervals of about 1 second, start over from step 1. Specifications nn Audio section • Power amplifier Rated output: Output connectors: • Analog Input sensitivity/Input impedance: Frequency response: S/N: nn Video section • Standard video connectors Input/output level and impedance: Frequency response: nn Tuner section Receiving Range: Usable Sensitivity: 50 dB Quieting Sensitivity: S/N (IHF-A): Total harmonic Distortion (at 1 kHz): nn General Power supply: Power consumption: nn Remote control unit (RC-1158) Batteries: Maximum external dimensions: Weight: Front: 75 W + 75 W (8 Ω, 20 Hz - 20 kHz with 0.08 % T.H.D.) 110 W + 110 W (6 Ω, 1 kHz with 0.7 % T.H.D.) Center: 75 W (8 Ω, 20 Hz - 20 kHz with 0.08 % T.H.D.) 110 W (6 Ω, 1 kHz with 0.7 % T.H.D.) Surround: 75 W + 75 W (8 Ω, 20 Hz - 20 kHz with 0.08 % T.H.D.) 110 W + 110 W (6 Ω, 1 kHz with 0.7 % T.H.D.) 6 - 16 Ω 200 mV/47 kΩ 10 Hz - 100 kHz - 0, -3 dB (DIRECT mode) 98 dB (IHF-A weighted, DIRECT mode) 1 Vp-p, 75 Ω 5 Hz - 10 MHz - 0, -3 dB [FM] (Note: μV at 75 Ω, 0 dBf = 1 x 10-15 W) 87.5 MHz - 107.9 MHz 1.2 μV (12.8 dBf) MONO 2.8 μV (20.2 dBf) MONO 70 dB STEREO 67 dB MONO 0.7 % STEREO 1.0 % AC 120 V, 60 Hz 330 W 0.5 W (Standby) [AM] 520 kHz - 1710 kHz 18 μV R03/AAA Type (two batteries) 1-31/32" (W) x 8-5/16" (H) x 55/64" (D) (50 x 211 x 22 mm) 3.9 oz (110 g, including batteries) For purposes of improvement, specifications and design are subject to change without notice. Information 57