Denon AVR 688 Owners Manual - English - Page 45

Quick Select Function With this function, the currently playing input source, input mode, surround mode, room EQ settings and volume can be stored in the memory. 1 Set the input source, input mode, surround mode, room EQ settings and volume to the conditions you want to store. 2 Press and hold until "Memory" appears on the display. Last Function Memory This stores the settings as they were directly before the standby mode was set. When the power is turned back on, the settings are restored to as they were directly before the standby mode was set. Backup Memory The various settings are backed up for about 1 week, even if the power is turned off or the power cord is disconnected. [Quick Select Defaults] Quick Select 1 Quick Select 2 Quick Select 3 Input Source DVD/HDP TV/CBL VCR Volume -40 dB -40 dB -40 dB To call out the settings, press at which the desired settings were stored. Personal Memory Plus Function This function sets the settings (input mode, surround mode, etc.) last selected for the individual input sources. When you switch to an input source, the settings are automatically set to the ones that were set the last time that input source was used. Resetting the Microprocessor Perform this procedure if the display is abnormal or if operations cannot be performed. When the microprocessor is reset, all the settings are reset to their default values. 1 Turn off the power using . 2 Press while simultaneously pressing and . 3 Once the display starts flashing at intervals of about 1 second, release the two buttons. If in step 3 the display does not flash at intervals of about 1 second, start over from step 1. The surround parameters, tone control, room EQ settings and the volumes of the different speakers are stored for the individual surround modes. ENGLISH 42 Getting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting