Denon AVR 788 Owners Manual - English - Page 26
Error Messages, Option, Parameter Check - wired subwoofer
UPC - 081757507868
View all Denon AVR 788 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Getting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting ENGLISH Error Messages If the auto setup procedure could not be completed due to speaker installation, the measuring environment, etc., an error message is displayed. If this happens, check the relevant items, be sure to take the necessary measures, then perform the auto setup procedure over again. Error messages (examples) Auto Setup Audyssey MultEQ Caution! Microphone:None or Speaker :None Cause Measures • Included setup microphone is not connected. • Connect the included setup microphone to the SETUP MIC jack on the main unit. • Not all speakers could be detected. • Check the speaker connections. s Option Make various other settings. Room EQ Select room EQ setting method. [Selectable items] All : A pply settings to all surround modes. Assign : M ake settings for each surround mode separately. Retry Cancel Auto Setup Audyssey MultEQ Caution! Ambient noise is too high or Level is too low. Retry Cancel Auto Setup Audyssey MultEQ Caution! Front R :None Retry Cancel Auto Setup Audyssey MultEQ Caution! Front L :Phase Retry Cancel Skip • Too much noise in the room for accurate • Either turn off any device generating noise or move it measurements to be made. away. • Try again when the surroundings are quieter. • Speaker or subwoofer sound is too low for • Check the speaker installation and the direction in accurate measurements to be made. which the speakers are facing. • Adjust the subwoofer's volume. • Displayed speaker could not be detected. • Check the connections of the displayed speaker. · The front R speaker were not properly detected. · Only one channel of the surround speakers was detected. · Sound was output from the R channel when only one surround back speaker was connected. · The surround back, but the surround speaker was not detected. • Displayed speaker connected with the • Check the polarities of the displayed speaker. polarities reversed. • For some speakers, this error message may be displayed even if the speaker is properly connected. If you are sure that the wiring is correct, select "Skip". Direct Mode Setup Select room EQ use for DIRECT or PURE DIRECT mode. [Selectable items] ON : Use room EQ. OFF : Do not use room EQ. d Parameter Check Check auto setup measurement results. This is displayed after the auto setup procedure is completed. [Selectable items] Speaker Config. Check Channel Level Check EQ Check Distance Check Crossover Freq. Check The auto setup results can be set again when "Restore" is selected. Select "Retry" to measure again. NOTE Be sure to turn the power off before checking the speaker connections. 23