Denon AVR 788 Owners Manual - English - Page 28

Getting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting ENGLISH Distance measurement Select the speaker you want to set, then set the distance. Set the value closest to the measured distance. [Variable range] 0.0ft ~ 60.0ft : Display when "Feet" is set. 0.00m ~ 18.00m : Display when "Meters" is set. NOTE Set the distance between the listening position and the various speakers to no more than 20.0 ft (6.00 meters). f Channel Level Adjust channel levels to obtain equal volume from all speakers. Test Tone Select test tone playback method. [Selectable items] Auto : A utomatically switch speaker from which test tone is output. Manual : M anually switch speaker from which test tone is output. Test Tone Start Output test tone. [Variable range] -12dB ~ 0dB ~ +12dB Default Resets the settings to the default values. Operating from the remote control unit Adjusting with the remote control unit using the test tones is only possible in the "Auto" mode and only effective in the STANDARD mode. The adjusted levels for the different modes are automatically stored in the memory. GAdjusting using test tonesH q Press the TEST button. Test tones are output from the various speakers. w Use the o p button to adjust so that the volume is equal for all speakers. e When the adjustments are completed, press the TEST button again. • When the menu "Speaker Configuration" - "Surround Back Speaker" setting (vpage 24) is set to "1spkr", the surround back speaker display is set to "Surround Back Sp." . • Speakers set to "None" in the "Speaker Configuration" settings are not displayed. • When "Channel Level" is adjusted, the adjusted values are set for all the surround modes. To adjust the channel level separately for the different surround modes, use the operation see page 46. g Crossover Frequency Select crossover frequency from which subwoofer handles low range signal. [Selectable items] 40Hz 60Hz 80Hz 90Hz 100Hz 110Hz 120Hz 150Hz 200Hz 250Hz : Only the portion of the bass sound of the various speakers output from the subwoofer that has a frequency below the frequency set here is output. Set this according to the low frequency reproduction capabilities of the speakers you are using. Advanced : Set the crossover frequency separately for the different speakers. • The "Crossover Frequency" can be set when there are speakers that have been set to "Small" at menu "Speaker Configuration" or when "Subwoofer" is set to "Yes" (vpage 24). • If in the "Advanced" settings, "Subwoofer Setup" (vpage 24) in the menu is set to "LFE", it is possible to make this setting for speakers set to "Small" at "Speaker Configuration". If set to "LFE+Main", this setting can be made regardless of the speaker size. • For speakers set to "Small", sound below the crossover frequency is cut from the sound output. The cut bass sound is output from the subwoofer or front speakers. • Always set the crossover frequency to "80 Hz". When using small speakers, however, we recommend setting the crossover frequency to a higher frequency. HDMI Setup Make settings for HDMI audio output. F Menu screen F 2.Manual Setup 1.Speaker Setup 2.HDMI Setup 3.Audio Setup 4.Zone2 Setup 5.Option Setup 2-2.HDMI Setup HDMI Audio Out AMP HDMI Audio Out Select HDMI audio output device. [Selectable items] AMP : U se speakers connected to receiver for audio playback. TV : U se speakers of monitor for audio playback. 25