Dewalt DC411B Instruction Manual - Page 15

English ASSEMBLY AND ADJUSTMENTS Attaching Side Handle The side handle (E) can be fitted to either side of the gear case in the threaded holes. Before using the tool, check that the handle is tightened securely. To improve user comfort, the gear case will rotate 90˚ for cutting operations. E WARNING: Accessories must be rated for at least the speed recommended on the tool warning label. Wheels and other accessories running over their rated accessory speed may fly apart and cause injury. Threaded accessories must have a 5/8"-11 hub. Every unthreaded accessory must have a 7/8" (22.2 mm) arbor hole. If it does not, it may have been designed for a circular saw. Use only the accessories shown on pages 14 and 15 of this manual. Accessory ratings must always be above tool speed as shown on tool nameplate. Rotating the Gear Case WARNING: To reduce the risk of serious personal injury, turn tool off and and remove battery pack before making any adjustments or removing/installing attachments or accessories. 1. Remove the four corner screws attaching the gear case to motor housing. 2. Without separating the gear case from motor housing, rotate the gear case head to desired position. NOTE: If the gear case and motor housing become separated by more than 1/8" (3.17 mm), the tool must be serviced and re-assembled by a DEWALT service center. Failure to have the tool serviced may cause brush, motor and bearing failure. 3. Re-install screws to attach the gear case to the motor housing. Tighten screws to 20 in.-lbs. torque. Overtightening could cause screws to strip. Accessories It is important to choose the correct guards, backing pads and flanges to use with grinder accessories. See pages 14 and 15 for information on choosing the correct accessories. Mounting Guard MOUNTING AND REMOVING GUARD WARNING: To reduce the risk of serious personal injury, turn tool off and and remove battery pack before making any adjust- ments or removing/installing attachments or accessories. CAUTION: Guards must be used with all grinding wheels, cutting wheels, sanding flap discs, wire brushes, and wire wheels. The tool may be used without a guard only when sanding with conventional sanding discs. DEWALT model DC411 is provided with a guard intended for use with depressed center wheels (Type 27) and hubbed grinding wheels (Type 27). The same guard is designed for use with sanding flap discs (Type 27 and 29) and wire cup brushes. Grinding and cutting with wheels other than Type 27 and 29 require different accessory guards included with tool. A Type 1 guard is provided for use with a Type 1 wheel. Mounting instructions for L these accessory guards are included in the accessory package. 1. Open the guard latch (K), and align the lugs (L) on the guard with the slots on the gear case (M). This will align the M lugs on the guard with the slots on the K gear case cover. 13