Dewalt DXCM201 Instruction Manual - Page 24
Glossary
View all Dewalt DXCM201 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
English FREE WARNING LABEL REPLACEMENT: If your warning labels become illegible or are missing, call 1-888-895-4549 for a free replacement. HOT SURFACE. RISK OF BURNS. DO NOT TOUCH. SUPERFICIE CALIENTE. RIESGO DE QUEMADURAS. NO TOCAR. SUURFACE TRÈS CHAUDE. RISQUES DE BRÛLURES. NE PAS TOUCHER. N008806 ATENCION RISK OF BURSTING PREVENT TANK CORROSION. AFTER EACH USAGE, DRAIN ALL MOISTURE FROM TANK. DRAIN VALVE LOCATED ON BOTTOM OF TANK. RISQUE D'ÉCLATEMENT PRÉVENIR LA CORROSION EN DRAINANT TOUTE HUMIDITÉ DU RÉSERVOIR APRÈS CHAQUE USAGE. DRENAR LA VÁLVULA UBICADA DEBAJO DEL TANQUE . RIESGO DE EXPLOSIÓN PREVENIR LA CORROSIÓN DEL TANQUE. DESPUÉS DE CADA USO DRENAR TODA HUMEDAD DEL TANQUE. SOUPAPE DE VIDANGE SITUÉE SUR LE DESSOUS DU RÉSERVOI. E106191 GLOSSARY CFM: Cubic feet per minute. SCFM: Standard cubic feet per minute; a unit of measure of air delivery. PSI: Pounds per square inch; a unit of measure of pressure. Cut-in pressure: Factory set low pressure point that starts the compressor to repressurize the tank to a higher pressure. Cut-out pressure: Factory set high pressure point that stops the compressor from increasing the pressure in the tank above a certain level. Well-ventilated: A means of providing fresh air in exchange for dangerous exhaust or vapors. Dedicated circuit: An electrical circuit reserved for the exclusive use of the air compressor. ASME: American Society of Mechanical Engineers. Indicates that the components are manufactured, tested and inspected to the specifications set by ASME. CSA: Canadian Standards Association Indicates that the products that have this marking have been manufactured, tested and inspected to standards that are set by CSA. Canadian Standards Association (USA): Indicates that the products that have this marking have been manufactured, tested and inspected to standards that are set by CSA. These products also conform to U.L. standard 1450. California Code: Unit may comply with California Code 462 (l) (2)/ (M) (2). Specification/model label is on the side of the air tank on units that comply with California Code. 24