Dewalt DXCM201 Instruction Manual - Page 27

English CODE 14 15 16 17 18 19 20 21 22 23 24 25 POSSIBLE CAUSE POSSIBLE SOLUTION Belt too tight. Check belt tension, see Adjusting Belt Tension under Maintenance. Pulley misalignment. See Motor Pulley/Flywheel Alignment under Maintenance. Pump oil is low. Add full synthetic, non-detergent air compressor oil to pump. See Compressor Pump Oil under Maintenance. Detergent type oil being used in pump. Drain oil and refill pump with full synthetic non-detergent air compressor oil. Extremely light duty cycles. Run unit for longer duty cycles. Piston rings damaged or worn. Contact a DeWALT factory service center or a DeWALT authorized service center. Cylinder or piston damaged or worn. Contact a DeWALT factory service center or a DeWALT authorized service center. Compressor cylinder finish worn. Contact a DeWALT factory service center or a DeWALT authorized service center. Water in pump oil. Drain oil and refill pump with full synthetic non-detergent air compressor oil. Regulator is not adjusted correctly for accessory being used. It is normal for some pressure drop to occur when and accessory is used, adjust the regulator as instructed in Regulator under Features if pressure drop is excessive. NOTE: Adjust the regulated pressure under flow conditions while the accessory is being used. Damaged regulator. Replace Regulator open. Rotate the regulator knob counter-clockwise to its built-in stop. 27