Dewalt DXPW1200-E Instruction Manual - Page 5
Fault Circuit Interrupter GFCI power plug. This cord should
View all Dewalt DXPW1200-E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
&OHMJTI plug must be plugged into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances. WARNING: Improper connection of the equipment-grounding conductor can result in a risk of electrocution. Check with a qualified electrician or service person if you are in doubt as to whether the outlet is properly grounded. Do not modify the plug provided with the product if it will not fit the outlet installed by a qualified electrician. Do not use any type of adaptor with this product. GROUND-FAULT CIRCUIT INTERRUPTER PROTECTION This pressure washer is provided with a Ground-Fault CircuitInterrupter (GFCI) built into the plug of the power supply cord. This device provides additional protection from the risk of electric shock. Should replacement of the plug or cord become necessary, use only identical replacement parts that include GFCI protection. 1PXFS4VQQMZ"OE&MFDUSJDBM*OGP GROUND-FAULT CIRCUIT INTERRUPTER PROTECTION The pressure washer is factory-equipped with an electrical cord and a Ground Fault Circuit Interrupter (GFCI) power plug. This cord should only be connected to an electrical outlet installed in accordance with local safety regulations. NOTE: The power supply must be 120 V, 60 Hz and a minimum 15 amp dedicated circuit. A. Inspect cord before using. Do not use if cord is damaged. B. Keep all connections dry and off the ground. C. Do not touch plug with wet hands. D. The pressure washer is provided with a ground fault circuit interrupter built into the power plug. If replacement of the plug or cord is needed, use only identical replacement parts. Contact customer service for proper replacement parts. WARNING: Test GFCI before each use. DO NOT use pressure washer if test below fails. GFCI Test Procedures: 1. Plug GFCI into power receptacle. Indicator light should illuminate. 2. Press test button (M). Light should turn N off. M 3. Press reset button (N) for use. Indicator light should illuminate. Do not use if above test fails. NOTE: The GFCI must be reset each time the pressure washer is connected to an electrical outlet. Reset by simply pushing the reset button on the GFCI power plug. EXTENSION CORDS Use only extension cords that are intended for outdoor use. These extension cords are identified by a marking "Acceptable for use with outdoor appliances: store indoors while not in use". Use only extension cords having an electrical rating not less than the rating of the product. Do not use damaged extension cords. Examine extension cord before using and replace if damaged. Do not abuse extension cord and do not yank on any cord to disconnect. Keep cord away from heat and sharp edges. Always disconnect the extension cord from the receptacle before disconnecting the product from the extension cord. When using an extension cord, observe the specification below: Cable Length Up to 25 ft. (7.5 m) Wire Gauge 12 AWG Outdoor WARNING: To reduce the risk of electrocution, keep all connections dry and off the ground. Do not touch plug with wet hands. 5