Dynex DX-55L150A11 User Manual (English) - Page 15

Turning on your TV for the first time DX-55L150A11 11 Turning on your TV for the first time To configure your TV: 1 Make sure that you have inserted the batteries in the remote control, connected your devices to the TV, and connected the AC power. 2 Press (Power), then wait several seconds. The Initial Setup screen opens (only the first time you turn on your TV). Follow the prompts to complete the setup. Setup Wizard Language Choose your menu Language English Espanõl Français Sutup Select ENTER ENTER Next Select 3 Press or to select the menu language you want, then press ENTER. The Picture Mode screen opens. Setup Wizard OSD LanguPaigceture MoEndgelish Screen Mode Normal Choose yoDuPrMpiScture Mode ON Time Setup Caption HomReesmeot dDeefault Retail mode Sutup Select ENTER Enter Select ENTER Next Back 4 Press or to select the Home Mode or Retail Mode, then press ENTER. Home Mode reduces the TV's total power consumption. The Tuner Mode screen opens. Setup Wizard OSD LanguTaugener ModEneglish Screen Mode Normal Choose yoDuPrMTuSner Mode ON Time Setup Caption AnRteensneat Default Cable Cable/Satelite Box Sutup Select ENTER Enter Select ENTER Next Back 5 Press or to highlight Antenna, Cable, or Satellite Box, depending on the type of connection you have, then press ENTER. The Channel screen opens. • If you are using an antenna for a standard or HD TV signal or if your cable TV is connected directly to the TV (without a box), select Antenna. • If a cable is connected to your TV, select Cable. • If your TV is connected to a cable/satellite box, select Cable/Satellite Box. 6 Press or to select Scan, then press ENTER. The channel scan begins. Your TV automatically scans for available channels in your area and stores the channel information in the channel list. This may take several minutes. While scanning, the TV displays a progress report. Notes: • Channel scan is not necessary if you are using a satellite or cable box. • Channel scan can take up to 30+ minutes. • You can press EXIT at any time to stop the auto scan, but you will need to run the auto scan again to create a channel list. Understanding the basics Turning your TV on or off To turn your TV on or off (standby mode): 1 Plug the power cord into an AC power outlet. 2 Press (power). Your TV turns on. 3 Press again to turn off your TV. When you turn off your TV, it goes into standby mode. Warning: When your TV is in standby mode, it is still receiving power. To completely disconnect power, unplug the power cord. Note: If your TV does not receive an input signal for several minutes, it automatically goes into standby mode. Selecting the video input source To select the video input source: 1 Turn on your TV, then press INPUT on the remote control or on the TV. The INPUT SOURCE menu opens. 2 Press or to highlight the video source you want, then press ENTER. Options include TV, AV1, AV2, Component1, Component2, VGA (computer), HDMI1, HDMI2, HDMI3, or HDMI4. Selecting a channel Tip: If you are using a cable or satellite box, use the remote control that came with that device to change channels. To select a channel: • Press CH /CH to go to the next or previous channel. • Press the number buttons to enter the channel number you want, then wait for the channel to change, or press ENTER to change the channel immediately.