Dynex DX-55L150A11 User Manual (English) - Page 8
TV components - base
View all Dynex DX-55L150A11 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
4 DX-55L150A11 TV components 3 Align the base with the TV, then secure the stand to the TV with the six screws (M6 x 12) provided. 3 Secure the wall-mount bracket to the back of your TV using the four screws provided with the bracket. Baseplate 4 Carefully lift the TV into an upright position. To remove the stand, see the following procedure. Removing the stand You must remove the stand before you can wall-mount the TV. Note: Your TV may differ from the illustrations shown. To remove the stand: 1 Lay the TV (screen down) on the edge of the table or bench. Make sure that you put a soft cloth or cushion between the table or bench and the TV. 2 Remove the six screws holding the stand to the TV, then remove the stand. TV components Front and side controls Installing a wall-mount bracket If you want to attach the TV to a wall-mount bracket (not provided), you should first remove the stand, if it has been installed. Warning: These instructions are for use by qualified service person only. To reduce the risk of hazards, do not perform any servicing other than that contained in the operating instructions unless you are qualified to do so. To install a wall-mount bracket: 1 Lay your TV face down on a table or bench. Make sure that you put down a soft cushion or cloth so that your TV is not scratched. 2 Remove the pedestal stand. See "Removing the stand" above. Item Name 1 MENU INPUT 2 VOL / VOL 3 CH /CH 4 (power) 5 6 Power indicator Remote control 7 sensor Description Press to open the on-screen menu. Press to open the INPUT SOURCE menu. For more information, see "Selecting the video input source" on page 11. In TV mode, press to increase or decrease the volume. In menu mode, press to move right or left or to adjust menu settings. In TV mode, press to select the next or previous channel. In menu mode, press to move up or down. Press to turn on the TV or put the TV in standby mode. Caution: The TV continues to receive power even in standby mode. Unplug the power cord to disconnect power. Lights red when your TV is in standby mode. Turns off when the TV is on. Receives signals from the remote control. Do not block. For more information, see "Aiming the remote control" on page 7.