Epson 2080 Service Manual - Page 27
CR Motor Driver Circuit - lq drivers
View all Epson 2080 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
LQ-2080 2.3.3 CR Motor Driver Circuit The CR motor driver circuit is shown below. Revision A The carriage motor driver circuit controls the CR motor, using an open-loop, constant drive arrangement. 2-2, 1-2, and W1-2 phases excite the motor. A 2-2 phase step is equivalent to a 1-2 phase step doubled. Ports 1, 8, 11, and 18 of the SLA7024M are used to change the excitation phase, depending on the selected print mode. Table 2-2 in the following page describes the motor driver modes. The SLA7024M (IC11) CR motor driver circuit detects and regulates the amount of current flowing in the carriage motor coil. The current flowing through the coil varies, depending on the speed of the CR motor. The CPU sets the amount of current and signals are sent via ports 32 to port 35. The SLA7024M sets the coil current, depending on the CR speed. Figure 2-6. CR Motor Driver Circuit Operating Principles Control Circuit 27