Epson 4000 Service Manual - Page 337
After installing Intermittent Gear, 40 onto Shaft
UPC - 010343848337
View all Epson 4000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 337 highlights
EPSON Stylus Pro 4000 7. Confirm that gears of "Intermittent Gear, 40" and "Release, Planetary Unit" are not engaged. If they are engaged, release engagement by moving "Release, Planetary Unit". (Refer to Figure 4-199.) 8. Rotate "Intermittent Gear, 40" in clockwise direction and look from the opposite side of the frame to align the hook and cut-out. (Refer to Figure 4-200.) 9. Remove "Intermittent Gear, 40" from printer body. (Refer to Figure 4-200.) CHECK P O IN T If "Intermittent Gear, 40" is difficult to remove, use tweezers or a similar tool to push and remove "Intermittent Gear, 40" by way of the hole on the opposite side of the frame. Be careful not to scratch "Intermittent Gear, 40". Install the "Intermittent Gear, 40" with its positioning rib matched with the "Shaft, Release, Roller Driven" phase position. Shaft, Release, Roller Driven Rib Phase After installing "Intermittent Gear, 40" onto "Shaft, Release, Roller Driven", turn it clockwise so the tab faces downward. Revision B Intermittent Gear, 40 Release, Planetary Unit Release engaged gears Figure 4-199. Intermittent Gear, 40 Removal_1 Step 9 Step 8 Tab and Cutout Figure 4-200. Intermittent Gear, 40 Removal_2 Tab Disassembly & Assembly Disassembly Procedures 337