Epson 680Pro User Manual - Page 99

Panel light state Beep pattern Problem Solution f Paper Out n Pause ••• Continuous paper is not fed back to the standby position. Tear off the printed document at the perforation; then press the Load/Eject button. The printer feeds the paper to the standby position. Press the Pause button to turn off the Pause light. ••• A single sheet of paper is not fully ejected. Press the Load/Eject button to eject the sheet. Then press the Pause button to turn off the Pause light, if necessary. ••• Paper is jammed in the printer. 5 Clear the paper jam as described in "Clearing Paper Jams" on page 5-16. f Paper Out f Pause ••• The printer was unable to switch between paper sources because of a paper jam or other paper problems. (LQ-680Pro only) Remove any paper from the paper path and clear the paper jam as described in "Clearing Paper Jams" on page 5-16. Then retry the paper source selection. f Pause - The print head is overheated. Wait a few minutes; the printer resumes printing automatically once the print head has cooled. f All the lights on the control panel An unknown printer error has occurred. Turn off the printer and leave it off for several minutes; then turn on the printer again. If the error recurs, contact your dealer. n = on, f = flashing short series of beeps (three beeps long series of beeps (five beeps) Note: The printer beeps once if you press a control panel button when the corresponding function is not available. Troubleshooting 5-3