Epson BrightLink EB-735Fi Installation Guide - Page 84
board surface, you must install the touch unit on the whiteboard., inches 51 mm
View all Epson BrightLink EB-735Fi manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 84 highlights
4. Slide the front of the bracket until the lower edge touches the projection surface. ❏ If the distance from the wall to the surface of the whiteboard is greater than 2 inches (51 mm), you must install the touch unit on the whiteboard. ❏ If the frame of the whiteboard extends more than 0.1 inch (3 mm) away from the board surface, you must install the touch unit on the whiteboard. 2 inches (51 mm) 0.1 inch (3 mm) 5. Tighten the screws (×2) at the top of the bracket that you loosened in step 1. 6. Remove the rubber caps (×2) from the front of the touch unit. 84
84
4.
Slide the front of the bracket until the lower edge touches the projection surface.
5.
Tighten the screws (×2) at the top of the bracket that you loosened in step 1.
6.
Remove the rubber caps (×2) from the front of the touch unit.
❏
If the distance from the wall to the surface of the whiteboard is greater than
2 inches (51 mm), you must install the touch unit on the whiteboard.
❏
If the frame of the whiteboard extends more than 0.1 inch (3 mm) away from the
board surface, you must install the touch unit on the whiteboard.
0.1 inch (3 mm)
2 inches (51 mm)