Epson EPL-N1200 Product Information Guide - Page 8

EPSON EPL-N1200 SelecType Settings Menu Test Emulation Printing Tray Size Config Setup Parallel B and Parallel C Items Status Sheet LJ4 Font Sample ESCP2 Font Sample FX Font Sample 1239X Font Sample PS Status Sheet PS Font Sample PS Fact Sheet Parallel B Parallel C Serial L/T (LocalTalk) AUX (another optional interface) Paper Source Page Size Orientation Copies Manual Feed Resolution MP Tray Size LC1 LC2 RITech * Toner Save * Density Top Offset Left Offset Size Ignore Auto Cont Page Protect ** Image Optimum Interface Time Out Standby Lang Toner Toner Count Clear Page Count SelecType Init Speed Bi-D *** Buffer Size Menu Serial Items Word Length Baud Rate Parity Stop Bit XOn/XOff DTR Buffer Size * You can also change these settings using OneTouch modes. ** Changing the Page Protect setting reconfigures your printer memory and may erase any downloaded fonts. ***Available only on the Parallel B menu. Note: You can also change these settings using the Remote Control Panel utility as described in the Technical Information manual. To match the computer's baud rate or set a higher one than that supported by your computer, see the Technical Information manual (this may not work with some computers). LT and AUX Menus The LT menu appears only when you have installed the LocalTalk/Serial module and have set the Emulation menu to LT. The AUX menu is available only when you have installed a Type B interface. Both menus have one menu item, Buffer Size, that sets the memory allocation used for the optional interface. You can set it to Maximum (more memory allocated for receiving data), Minimum (more memory allocated for printing data), or Normal (for balanced usage); Normal is the default. Menu LJ4 PS Menu Items FontSource Font Number Pitch Height SymSet * Form Source SymSet ** Dest SymSet ** Err Sheet Protect Level 8 - EPSON EPL-N1200 1/97