Epson WorkForce Enterprise WF-C17590 Users Guide - Page 77

Error code and message Solution E-12 Make sure other devices on the network are turned on and Confirm the following: do the following: -Entered security key/password is correct • Make sure the IP address, subnet mask, and default gateway addresses are correct, if you are entering them -Index of the security key/password is set to manually. the first number • Confirm that the subnet mask and default gateway -IP address, subnet mask, or default addresses for other devices are the same. gateway setup is correct • Make sure the IP address does not conflict with other Contact your network administrator for devices. assistance. If you still cannot connect to your product, do the following: • Turn off your router or access point, wait about 10 seconds, and turn it on again. • Download and install your product software again to reset your network settings. • If your router or access point uses WEP security with several registered passwords, make sure that the first registered password is set on your product. E-13 Make sure your router, access point, and/or hub are Confirm the following: turned on. Also make sure the TCP/IP setup on your router, access point, and/or hub is not set manually; this -Entered security key/password is correct may cause your product's network settings to differ from -Index of the security key/password is set to the manually set up devices. the first number If you still cannot connect to your product, do the -Connection and network setup of the PC following: or other device is correct • Turn off your router or access point, wait about 10 Contact your network administrator for seconds, and turn it on again. assistance. • Download and install your product software again to reset your network settings. • If your router or access point uses WEP security with several registered passwords, make sure that the first registered password is set on your product. 77