Fisher and Paykel DD24DCTX9 N Installation Guide - Page 4
Optionally Hard Wiring Prior To Installation, Remove The Lower Drawer, Remove The Access Cover &
View all Fisher and Paykel DD24DCTX9 N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
3 OPTIONALLY HARD WIRING PRIOR TO INSTALLATION 3-A REMOVE THE LOWER DRAWER To prevent kinked hoses Either sit the drawer down on the left hand side (recommended) or rotate the drawer clockwise, resting it on its side after removal. 3-B REMOVE THE ACCESS COVER & REMOVE POWER CORD 3 3 1 2 4" (100 mm) 4 Push drawer runners back in on either side. Sit the drawer down 3 Press the release tabs in on either side and push back to release drawer from runners. Lift drawer off runners. 4 Push drawer runners back in on either side. Rotate the drawer clockwise (max. 90o) and rest on side. 1 Clip Access cover 1 Clip 1 With a flat-bladed screwdriver, push in the clips and slide out the access cover. 2 Unscrew the electronics module cover. 3 Carefully pull out the electronics module and rest on the chassis base out of the way. 4 With a screwdriver, unclip the plastic harness cover and hinge open. 5 Slide the terminal block cover sideways to unlock and hinge open to access the terminal block. 6 Unscrew the Live, Neutral and Earth wires as shown. 7 Unscrew the three screws on the base as shown and remove the cord from the product. 2 Electronics module 5 Terminal Block cover 4 Remove existing power cord 7 6 7 3