Frigidaire FGGC3065KW Installation Instructions (All Languages) - Page 4

GAS COOKTOP INSTALLATION INSTRUCTIONS (For 30" & 36" Models) Typical Under Counter Installation of an Electric Built-in Oven with a Cooktop Mounted Above All mounting hardware must be used to secure the built-in oven to the cabinets. Refer to the built-in oven installation instructions. This cooktop may be installed over certain built-in electric oven models. Junction box must be located approx. 3" to the left of the built-in oven cutout. Side filler panels are necessary to isolate the unit from adjoining cabinets. Panel height should allow for installation of approved cooktop models. See "Typical Gas Cooktop Installation Over an Electric Built-in Oven Installed Under the Counter" on next page. 208/240 Volt grounded junction box for built-in oven. Cut an opening in wood base minimum 4" (10.2 cm) x 4" (10.2 cm) to route armored cable to junction box. Unit will overlap cutout (minimum) edges by 1" (2.5cm) 36" (91.4 cm) Min. Use 3/4" (1.9 cm) plywood, installed on two runners, flush with toe plate. Base must be capable of supporting 150 pounds (68 kg) for 27" models and 200 pounds (90 kg) for 30" models. 4 1/2" (11.4 cm) Max.* * If no cooktop is installed directly over the oven unit, 5" (12.7 cm) maximum is allowed. OVEN SIZE 30" (76.2) 27" (68.6) CUTOUT DIMENSIONS (INCHES (CM)) E. HEIGHT F. WIDTH Min. Max. Min. Max. 27 ¼" (69,2 cm) 28¼" (71.8) 28½" (72.4) 29" (73.7) 27 ¼" (69,2 cm) 28¼" (71.8) 247/8" (63.2) 25¼" (64.1) G. Depth Min. 23½" (59.7) 23½" (59.7) Figure 3 4