Fujitsu E8110 E8110 User's Guide - Page 64

E8110.book Page 54 Tuesday, February 28, 2006 2:59 PM LifeBook E8000 Notebook Problem Possible Cause Possible Solutions You have installed an external keyboard or mouse, and it does not seem to work. Your external device is not properly installed. Re-install your device. (See Device Ports on page 46 for more information) Your operating system soft- Check your device and operating system docuware is not set up with correct mentation and activate the proper driver. software driver for that device. You have connected an external keyboard or a mouse and it seems to be locking up the system. Your operating system soft- Check your device and operating system ware is not setup with correct documentation and activate the proper driver. software driver for that device. Your system has crashed. Try to restart your notebook. I Memory Problems Your Power On screen does not show the correct amount of installed memory. Your memory upgrade module is not properly installed. You have a memory failure. Remove and re-install your memory upgrade module. (See Memory Upgrade Module on page 44 for more information) Check for Power On Self Test (POST) messages. (See Power On Self Test Messages on page 60 for more information) Modem Problems Messages about modem operation. Messages about modem operation are generated by whichever modem application is in use. See your application software documentation for additional information. Parallel, Serial, and USB Device Problems You have installed a parallel port device, a serial port device or a USB device. Your LifeBook notebook does not recognize the device, or the device does not seem to work properly. The device is not properly installed. The device may have been installed while an application was running, so your notebook is not aware of its installation. Your device may not have the correct software driver active. Remove and re-install the device. (See Device Ports on page 46 for more information) Close the application and restart your notebook. See your software documentation and activate the correct driver. You may have the wrong I/O address selected for your device. See your device documentation and software documentation to determine the required I/O address. Change the settings in the BIOS setup utility. (See BIOS Setup Utility on page 29 for more information) Your device and another device Check all I/O addresses located within the BIOS are assigned the same I/O setup utility and any other installed hardware or address. software to make sure there are no duplications. Parallel port is set to output only. Check parallel port setting in the BIOS and set to bi-directional or ECP. PC Card/ExpressCard Problems A card inserted in the PC Card or ExpressCard slot does not work or is locking up the system. The card is not properly installed. Remove and re-install the card. (See PC Cards/ ExpressCards™ on page 42 for more information) 54