Fujitsu S510M Getting Started Guide - Page 18

5. Daily Care This chapter describes how to clean the ScanSnap scanner. WARNING Fire/Electric Shock Before cleaning the scanner, unplug the AC adapter cord from the power outlet. 5.1. Cleaning Materials Cleaning Materials Parts No. Cleaner F1 PA03950-0352 Remarks 1 bottle (100ml) *1, *2 *1) When purchasing the cleaning material, contact the FUJITSU scanner dealer from whom you purchased the scanner. *2) It may take long before the cleaner vaporizes if a large quantity is used. When cleaning the scanner parts, dampen a cloth with modest quantities of the cleaner. In addition, wipe off the cleaner completely with a soft lint-free cloth to leave no residue on the surface of the cleaned parts. 5.2. Cleaning the Scanner Exterior Clean the scanner exterior and the Paper chute with a dry cloth moistened with a small amount of neutral detergent or Cleaner F1. ATTENTION ● Never use paint thinner or other organic solvents. ● During the cleaning, take care not to let water or other moistures getting into the inside of the scanner. ● Do not use aerosol sprays to clean the scanner. Aerosol sprays cause dust to enter the scanner, resulting in scanner failure or scanner malfunction. referring to the illustrations. CAUTION The glass surface inside the ADF becomes hot during the scanner operation. Before you start cleaning the inside of the scanner, unplug the AC adapter cord from the outlet, and wait at least 15 minutes to cool down the scanner. ATTENTION ● Never use water or neutral detergent to clean the inside of the scanner. ● Do not use aerosol sprays to clean the scanner. Aerosol sprays cause dirt and dust entering the scanner, resulting in scanner failure and scanner malfunction. 1. Pull the Cover open lever and open the ADF. ADF Cover open lever 2. Clean the parts indicated in the figure below with a cloth moistened with the Cleaner F1. Pad ASSY Plastic rollers (x4) Eject rollers (x2) Pick roller Cloth Neutral detergent or Cleaner F1 Paint thinner 5.3. Cleaning Inside of the scanner Clean inside of the scanner with a cloth moistened with Cleaner F1. Accumulated paper-powder and dust inside the scanner can cause a scanning error. As a guideline, clean the ADF every 1,000 scans. Note that this guideline varies according to the type of documents you are scanning. For example, you have to clean the ADF more frequently when scanning photocopied documents with poor toner adhesion or documents with penciled information. Clean the ADF according to the following procedure 16 | Feed rollers (x2) Glass (x2) (Located on the ADF cover and the base unit.)