Fujitsu S510M Getting Started Guide - Page 22
Fix the Pick roller bushing left by rotating it in
UPC - 097564307324
View all Fujitsu S510M manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
6. Remove the Pick roller with its shaft. Slightly pull up the left part of the Pick roller shaft about 1/5 inch (5 mm), move it towards the left side, and then raise it to remove from the scanner. 9. Install the Pick roller with its shaft into the scanner. And set the shaft to the slot while lowering it. Bushing Pick roller shaft Pick roller ATTENTION If the parts around the pick roller become dirty because of paper-powder, it may cause a scanning error. Please remove the dirt using a dry cloth moistened with Cleaner F1. * Don't use water, mild detergent or air-spray. 7. Remove the Pick roller from the shaft. Pull out the shaft from the Pick roller while lifting up its tab. Tab Pick roller shaft Pick roller 10. Fix the Pick roller bushing (left) by rotating it in the direction of the arrow. Pick roller Pick roller bushing ATTENTION Pick roller shaft Pick roller It may crack or chip your fingernail. If you worry about that, push up the pick roller tab using a paper clip. 1 2 Pick roller shaft ATTENTION Make sure that the Pick roller is completely attached and correctly installed. Otherwise, document jams or other feeding errors may occur. 11. Attach the sheet guide to the scanner. While holding the handle on the sheet guide, set the sheet guide into the scanner. Sheet guide Handle Craw 8. Attach a new Pick roller to the shaft. Insert the Pick roller shaft aligning the key with the slot on the Pick roller. Pick roller shaft 20 | Pick roller Slot Key Ö You should hear the sheet guide click when it returns to its original position.