Garmin GPSMAP 741xs Owner's Manual - Page 38

Viewing Information Cycling Through Engine Gauge Screens 1. From the Home screen, select Information > Dashboard > Engine. 2. Select the left and right arrows on the Rocker to move from one gauge screen to the next. Customizing Engine Gauge Limits To establish the upper and lower limits of a gauge and the range of desired standard operation, you can configure up to four values for the engine gauge. When a value exceeds the range of standard operation, the gauge face or bar becomes red. Setting Description Scale This value is less than the rated minimum, and it represents minimum the lower limit of the gauge. This setting is not available on all gauges. Scale This value is greater than the rated maximum, and it maximum represents the upper limit of the gauge. This setting is not available on all gauges. Rated Represents the minimum value of the standard operating minimum range. Rated Represents the maximum value of the standard operating maximum range. 1. From the Home screen, select Information > Dashboard > Engine > MENU > Gauge Setup > Set Gauge Limits. 2. Select a gauge. 3. Select Gauge Limits > Custom. 4. Select the gauge limit you want to set (Scale Min, Scale Max, Rated Min, or Rated Max). NOTE: Some of these options may not be available for all gauges. 5. Select the gauge limit. 6. Repeat steps 4 and 5 to set additional gauge limits. Activating Status Alarms for Engine Gauges If you have activated gauge status alarms, when the engine sends a warning status message over the NMEA 2000 network, a gauge status alarm message appears. The gauge face or bar may become red depending on the alarm type. From the Home screen, select Information > Dashboard > Engine > MENU > Gauge Setup > Status Alarms > On. Customizing Engine Gauge Status Alarms 1. From the Home screen, select Information > Dashboard > Engine > MENU > Gauge Setup > Status Alarms > Custom. 2. Select one or more engine gauge alarms that you want to turn on or off. 3. Select Back. Selecting the Number of Engines Shown in Gauges The engine gauges can show information for up to four engines. 1. From the Home screen, select Information > Dashboard > Engine > MENU > Gauge Setup > Engine Selection > Num. Engines. 2. Select the number of engines. 3. Select Back. To select the engines for which information appears in the gauges, select Edit Engines and complete steps 2 through 5 of "Selecting the Engines Shown in Gauges" (following section). 32 GPSMAP 400/500 Series Owner's Manual