Garmin aera 560 Pilot's Guide - Page 148
Attaching the yoke mount to the yoke shaft or control arm, Attaching the aera to the yoke mount - panel mount
View all Garmin aera 560 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 148 highlights
Overview GPS Navigation Appendix D Attaching the yoke mount to the yoke shaft or control arm: 1) Open the clamp by turning the Clamp Adjustment Knob until it can be easily placed over the yoke shaft or control arm. Install the yoke mount as far from the panel as is practical. 2) When in place, tighten the Clamp Adjustment Knob to secure the yoke mount to the yoke shaft or control arm. 3) Loosen the Cradle Adjustment Knob, then orient the aera as desired. 4) Tighten the Cradle Adjustment Knob to hold the aera in place. 5) Connect power/data cables. Attaching the aera to the yoke mount: 1) Fit the bottom of the aera into the cradle. 2) Tilt the aera back until it snaps into place. Removing the aera from the yoke mount: 1) Press the Release Button on the side of the mount to release the aera. 2) Lift out the aera. Release Button aera Cradle aera Additional Features Hazard Avoidance Flight Planning Appendices Index Cradle Adjustment Knob Yoke Mount Assembly 136 Garmin aera 500 Series Pilot's Guide 190-01117-02 Rev. A