GE AJCS12DCC Owners Manual - Page 4

Consumer Support Troubleshooting Tips Installation Instructions Care and Cleaning Operating Instructions Safety Instructions About the controls on the air conditioner-models with touch pads. Appearance may vary. Timer On Timer Off Sleep Cool Fan High Med Low On Air Conditioner Controls Lights beside the touch pads on the air conditioner control panel indicate the selected settings. Controls Remote Control When the air conditioner is turned on, it will automatically start in the setting last used. ON/STOP Turns air conditioner on and off. Display MODE On the remote control, use to set the air conditioner to COOL or FAN mode. On the air conditioner controls, use to set COOL or FAN mode at HIGH, MED or LOW fan speed. Indicator lights on the air conditioner controls will show the mode and fan speed selected. TEMP Increase L /Decrease M Pads Use to set temperature when in COOL mode. Fan Speeds (Remote control only) Use to set the fan speed at LOW, MED or HIGH. TIMER ON-When the air conditioner is off, it can be set to automatically turn on in half an hour to 24 hours at its previous setting. Each touch will set the time in half hours up to 10 and then in hours up to 24. To cancel (CL) the On Timer press the ON pad again. OFF-When the air conditioner is on, it can be set to automatically turn off in half an hour to 24 hours. Each touch will set the time in half hours up to 10 and then in hours up to 24. To cancel (CL) the Off Timer press the OFF pad again. To cancel the timer, press the ON or OFF pads until the display time disappears. SLEEP Press to set the air conditioner to run for 8 hours before it automatically returns to the previous setting. When the sleep timer is set, the set temperature will automatically increase 2°F after the second hour then 1°F each hour over the next two hours. To cancel the sleep mode, press the MODE pad or the SLEEP pad a second time. Remote Control Signal Receiver Remote Control I To ensure proper operation, aim the remote control at the signal receiver on the air conditioner. I Make sure nothing is between the air conditioner and the remote control that could block the signal. I The remote control signal has a range of I Make sure batteries are fresh and installed 4 up to 21 feet. correctly-see the Care and Cleaning section.