GE C2S980S Use and Care Manual - Page 30

After a Clean Cycle, How to Delay the Start of Cleaning, CLOCK, COOKING TIME, SELF CLEAN

Get GE C2S980S - Cafe 30 in. Dual-Fuel Range PDF manuals and user guides View all GE C2S980S manuals
Add to My Manuals
Save this manual to your list of manuals

Page 30 highlights

Operating Instructions Safety Instructions Using the self-cleaning upper oven. The oven door must be closed and all controls set correctly for the cycle to work properly. How to Delay the Start of Cleaning Make sure the clock shows the correct time of day. NOTE: The surface burners must be turned off prior to the self-clean start time. Touch the SELF CLEAN pad. NOTE: If the display shows LOC, touch and hold the GAS/CONTROL LOCKOUT pad for 3 seconds to turn it off. See the Gas/Control Lockout section. Using the number pads, enter the desired clean time. Touch the DELAY START pad. The earliest start time you can set will appear in the display. Using the number pads, enter the time of day you want the clean cycle to start. Touch the START pad. The door locks automatically. The display will show the start time. It will not be possible to open the oven door until the temperature drops below the lock temperature and the LOCKED DOOR light goes off. The oven shuts off automatically when the clean cycle is complete. When the LOCKED DOOR light is off, the door will unlock automatically. ■ The words LOCK DOOR will flash and the oven control will signal if you set the clean cycle and forget to close the oven door. ■ To stop a clean cycle, touch the CLEAR/OFF pad. When the LOCKED DOOR light goes off indicating the oven has cooled below the locking temperature, you may open the door. After a Clean Cycle You may notice some white ash in the oven. Wipe it up with a damp cloth after the oven cools. If white spots remain, remove them with a soap-filled scouring pad and rinse thoroughly with a vinegar and water mixture. These deposits are usually a salt residue that cannot be removed by the clean cycle. If the oven is not clean after one clean cycle, repeat the cycle. ■ You cannot set the oven for cooking until the oven is cool enough for the door to unlock. ■ While the oven is self-cleaning, you can touch the CLOCK pad to display the time of day. To return to the clean countdown, touch the COOKING TIME pad. ■ If the shelves become hard to slide, apply a small amount of vegetable oil or cooking oil to a paper towel and wipe the edges of the oven shelves with the paper towel. Installation Instructions Consumer Support Troubleshooting Tips 30

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
Operating Instructions
Safety Instructions
Installation
Instructions
Troubleshooting Tips
Consumer Support
30
The oven door must be closed and all controls set correctly for the cycle to work properly.
After a Clean Cycle
You may notice some white ash in the
oven. Wipe it up with a damp cloth after
the oven cools.
If white spots remain, remove them with a
soap-filled scouring pad and rinse thoroughly
with a vinegar and water mixture.
These deposits are usually a salt residue
that cannot be removed by the clean cycle.
If the oven is not clean after one clean cycle,
repeat the cycle.
■
You cannot set the oven for cooking until
the oven is cool enough for the door to
unlock.
■
While the oven is self-cleaning, you can
touch the
CLOCK
pad to display the time
of day. To return to the clean countdown,
touch the
COOKING TIME
pad.
■
If the shelves become hard to slide, apply a
small amount of vegetable oil or cooking oil
to a paper towel and wipe the edges of the
oven shelves with the paper towel.
Using the self-cleaning upper oven.
How to Delay the Start of Cleaning
Make sure the clock shows the correct time of
day.
NOTE:
The surface burners must be turned off
prior to the self-clean start time.
Touch the
SELF CLEAN
pad.
NOTE:
If the display shows
LOC
, touch
and hold the
GAS/CONTROL LOCKOUT
pad for 3 seconds to turn it off. See the
Gas/Control Lockout
section.
Using the number pads, enter the
desired clean time.
Touch the
DELAY START
pad. The
earliest start time you can set will
appear in the display.
Using the number pads, enter the time
of day you want the clean cycle to start.
Touch the
START
pad.
The door locks automatically. The display will
show the start time. It will not be possible to
open the oven door until the temperature
drops below the lock temperature and the
LOCKED DOOR
light goes off.
The oven shuts off automatically when the
clean cycle is complete.
When the
LOCKED DOOR
light is off,
the door will unlock automatically.
■
The words
LOCK DOOR
will flash and the
oven control will signal if you set the clean
cycle and forget to close the oven door.
■
To stop a clean cycle, touch the
CLEAR/OFF
pad. When the
LOCKED DOOR
light goes off indicating the oven has
cooled below the locking temperature,
you may open the door.