GE C2S980S Use and Care Manual - Page 50

Operating Instructions Safety Instructions Installation of the range. Seal the Openings Seal any openings in the wall behind the range and in the floor under the range when hookups are completed. Assemble Surface Burners Burner Heads (on some models) Place burner heads over the electrodes on the cooktop, in the correct locations according to their size. There is one small, one medium, one extra large and one dual flame extra large burner head. Medium head Small head Caps Place the matching size caps onto the burner bases or heads. Medium cap Small cap Extra large head Front of range Dual flame extra large head Front left, back right and back left burners Burner cap Front right burner Burner cap Burner head Burner head Stability chamber Electrode Burner base Burner base Electrode Make sure the slot in the burner head is positioned over the electrode. Make sure the hole in the burner head assembly is positioned over the electrode and that the burner head is fully inserted inside the burner base. A small gap between the base and head is normal. Oval (Center) Burner Head/Cap Assembly Place the oval (center) head/cap assembly over the electrode on the cooktop. Oval head and cap assembly Make sure the slot in the burner head is positioned over the electrode. Extra large cap Front of range Dual flame extra large cap Make sure that the heads and caps are replaced in the correct locations. Grates Place the left, right and center grates on the cooktop. These grates are position specific. The undersides of the left and right grates are marked "OUTSIDE." Place the middle grate with its bowed front toward the front of the range. Outside grate Center grate Outside grate CAUTION:Do not operate the burner without all burner parts in place. Installation Instructions Consumer Support Troubleshooting Tips Front of range Slot Electrode 50