GE P2B940SEJSS Use and Care Manual - Page 30
Warning, Caution
View all GE P2B940SEJSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
CARE AND CLEANING: Maintenance Maintenance Oven Light Replacement WARNING SHOCK OR BURN HAZARD: Before replacing oven light bulb, disconnect the electrical power to the oven at the main fuse or circuit breaker panel. Failure to do so may result in electric shock or burn. CAUTION BURN HAZARD: The glass cover and bulb should be removed when cool. Touching hot glass with bare hands or a damp cloth can cause burns. NOTE: The glass cover should be removed only when cold. Wearing latex gloves may offer a better grip. Before replacing the bulb, disconnect electrical power to WKHRYHQDWWKHPDLQIXVHRUFLUFXLWEUHDNHUSDQHO/HW the bulb cool completely before removing it. For your safety do not touch a hot bulb with a damp cloth. If you do the bulb may break. To remove: 7XUQWKHJODVVFRYHUFRXQWHUFORFNZLVHWXUQXQWLOWKH tabs of the glass cover clear the grooves of the socket and pull the cover off. Remove the bulb. To replace: Put in a new 40-watt appliance bulb. Place the tabs of the glass cover into the grooves of the socket. Turn the JODVVFRYHUFORFNZLVHWXUQ NOTE: Ŷ A 40-watt appliance bulb is smaller than a standard 40-watt household bulb. Ŷ R econnect electrical power to the oven once the new bulb is installed. Ŷ F or improved lighting inside the oven, clean the glass cover frequently using a wet cloth. This should be done when the oven is completely cool. 31ø2" Max length Socket Bulb Tab Glass cover Lift-Off Oven Door The door is very heavy. Be careful when removing and lifting the door. Do not lift door by the handle. To Remove the Door: 1. Fully open the door. 2. Pull the hinge locks up and away from the range frame to the unlocked position. )LUPO\JUDVSERWKVLGHVRIWKHGRRUQHDUWKHWRS 4. Close door until the top of the door is approximately ´IURPWKHUDQJHIUDPH /LIWGRRUXSDQGDZD\IURPWKHUDQJHXQWLOERWKKLQJH arms are clear of the slots in the range frame. To Replace the Door: 1. Firmly grasp both sides of the door near the top. 2. With the door at the same angle as the removal position, rest the notch on the underside of the left hinge arm on the bottom edge of the left hinge slot. The notch in the hinge arm must be fully seated into the bottom of the slot. Repeat for the right side. )XOO\RSHQWKHGRRU,IWKHGRRUZLOOQRWIXOO\ RSHQWKH notches in the bottoms of the hinge arms have not VHDWHGFRUUHFWO\LQWKHERWWRPHGJHRIWKHVORW/LIWWKH door off the range and repeat previous step. 4. Push the hinge locks toward the range cavity and down to the locked position. 5. Close the oven door. Pull hinge locks up to unlock Bottom edge of slot Hinge arm Notch Rest notch on bottom edge of hinge slot Removal position Push hinge locks down to lock 30 49-85222