GE PGB900 Owners Manual - Page 15

Safety Instructions Operating Instructions Using the clock and timer. Not all features are on all models. Make sure the clock is set to the correct time of day. To Set the Clock The clock must be set to the correct time of day for the automatic oven timing functions to work properly. The time of day cannot be changed during a timed baking or selfcleaning cycle. Touch the Clock pad. Touch the number pads. Touch the number pads the same way you read them. For example, to set 12:34, touch the number pads 1, 2, 3 and 4 in that order. GEAppliances.com If number pads are not touched within one minute after you touch the Clock pad, the display reverts to the original setting. If this happens, touch the Clock pad and reenter the time of day. Touch the Start pad until the time of day shows in the display. This enters the time and starts the clock. To check the time of day when the display is showing other information, simply touch the Clock pad. The time of day shows until another pad is touched. Installation Instructions The timer is a minute timer only. The Clear/Off pad does not affect the timer. To Set the Timer The timer does not control oven operations. The maximum setting on the timer is 9 hours and 59 minutes. Touch the Kitchen Timer On/Off pad. Touch the number pads until the amount of time you want shows in the display. The maximum time that can be entered in minutes is 59. Times more than 59 minutes should be changed to hours and minutes. For example, to enter 90 minutes as 1 hour 30 minutes, touch 1, 3 and 0 in that order. If you make a mistake, press the Kitchen Timer On/Off pad and begin again. Touch the Start pad. After pressing the Start pad, Set disappears; this tells you the time is counting down, although the display does not change until one minute has passed. When the timer reaches :00, the control will beep 3 times followed by one beep every 6 seconds until the Kitchen Timer On/Off pad is touched. The 6-second tone can be canceled by following the steps in the Special features of your oven control section under Tones at the End of a Timed Cycle. Troubleshooting Tips Consumer Support To Reset the Timer If the display is still showing the time remaining, you may change it by touching the Kitchen Timer On/Off pad and then touching the number pads until the time you want appears in the display. If the remaining time is not in the display (clock, delay start or cooking time are in the display), recall the remaining time by touching the Kitchen Timer On/Off pad and then touching the number pads to enter the new time you want. To Cancel the Timer Touch the Kitchen Timer On/Off pad twice. Power Outage If a flashing time is in the display, you have experienced a power failure. Reset the clock. Touch the Clock pad once to reset. Enter the correct time of day by touching the appropriate number pads. Touch the Start pad. 15