GE PNM9196SFSS Installation Instructions - Page 13
Caution, Warning
View all GE PNM9196SFSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Installation Instructions A2 86(723&$%,1(77(03/$7()25 PREPARATION OF TOP CABINET You need to drill holes for the top support screws, a hole large enough for the power cord to fit through, and a cutout large enough for the exhaust adaptor. A4 MOUNT THE OVEN Read the instructions on the TOP CABINET TEMPLATE. Tape it underneath the top cabinet. Drill the holes, following the instructions on the TOP CABINET TEMPLATE. CAUTION: 7RDYRLGWKHULVNRISHUVRQDO LQMXU\EDFNLQMXU\RURWKHULQMXULHVGXHWRH[FHVVLYH ZHLJKWRIWKHPLFURZDYH RUSURSHUW\GDPDJH\RX ZLOOQHHGWZRSHRSOHWRLQVWDOOWKLVPLFURZDYH IMPORTANT: Do not grip or use handle during installation. WARNING: 5LVNRI(OHFWULF6KRFN &DQFDXVHLQMXU\RUGHDWK,ILQVWDOOLQJXQLW ZLWKPHWDOFRXQWHUWRSVFRYHUWKHHGJHRIWKH power supply cord hole with the power supply cord EXVKLQJ IMPORTANT: If filler blocks are not used, case damage may occur from overtightening screws. CAUTION::HDUVDIHW\JRJJOHVZKHQ GULOOLQJKROHVLQWKHFDELQHWERWWRP A3 $66(0%/($1',167$//$'$3725 Tabs Remove Screw from Back of Blower Plate Damper NOTE: When mounting the microwave, thread power cord through hole in bottom of top cabinet. Keep it tight throughout Steps 1-3. Do not pinch cord or lift oven by pulling cord. 1 Lift microwave, tilt it forward, and hook slots at back bottom edge onto four lower tabs of mounting plate. Exhaust Adaptor Front of Oven Remove Screw from Top of Blower Plate Back of Oven Blower Plate 1 Place the oven in its upright position, with the top of the unit facing up and the front of the unit facing toward you. 2 Remove the screw on the back side of the blower plate and raise the blower plate off of the microwave. 3 Slide the damper from left to right into the tabs on the blower plate. The yellow tape on the damper should be facing you. If the blower plate is not raised off of the top of the microwave, the damper cannot slide into position. 4 Remove the yellow tape from the damper. 0DNHVXUH WKDWWKHGDPSHUSLYRWVHDVLO\EHIRUHPRXQWLQJRYHQ You will need to make adjustments to assure proper alignment with your house exhaust duct after the oven is installed. 2 Rotate front of oven up against cabinet bottom. 3 Insert a self-aligning screw through top-center cabinet hole. Temporarily secure the oven by turning the screw at least two full turns after the threads have engaged. (It will be completely tightened later.) 13