GE PNM9196SFSS Installation Instructions - Page 17
Be sure to trim the sharp, can cause injury or death., Do not pull or stretch, not pinched..
View all GE PNM9196SFSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Installation Instructions 5 Roll the blower unit 90° so that fan blade openings are facing out the back of the oven. Before Rolling After Rolling Back of Oven Back of Oven 6 Locate the two "knockout" plates, on the rear oven panel, near the top of the oven. Using tin snips, carefully cut the web area from the two holes side-by-side (that secure the knockouts to the oven). Cut all four webs on both rear knockouts; this will allow the ventilation fan airflow to exhaust out the rear of the oven. CAUTION: Be sure to trim the sharp HGJHVIURPWKHRSHQLQJVDIWHUUHPRYLQJWKH NQRFNRXWSODWHV 2YHQ5HDU3DQHO Snip all 4 webs on each knockout panel and remove the metal knockouts for rear airflow. 7 Place the blower unit back into the opening. AFTER: Fan Blade 2SHQLQJV)DFLQJ %DFN End A End B WARNING:5LVNRIHOHFWULFVKRFN can cause injury or death. Do not pull or stretch WKHEORZHUXQLWZLULQJPDNHVXUHWKHZLUHVDUH not pinched.. NOTE: The blower unit exhaust openings should match exhaust openings on rear of microwave. 8 Attach the exhaust adaptor to the rear of the oven by sliding it into the guides at the top center of the back of the oven. Exhaust Adaptor Damper (hinge side up) Screw Slide exhaust adaptor into guides on oven rear. Back of Oven Locking Tabs Guides Push down securely until it is in the lower locking tabs. Take care to assure the damper hinge is installed so that it is at the top and that the damper swings freely. 9 Close the blower plate so it is closed over the top tab of the exhaust adapter. Secure with the screw removed earlier. Blower Plate Back of Oven Screw Exhaust Adaptor 17