GE PNM9196SFSS Installation Instructions - Page 20

Warning - model #

Get GE PNM9196SFSS PDF manuals and user guides View all GE PNM9196SFSS manuals
Add to My Manuals
Save this manual to your list of manuals

Page 20 highlights

Installation Instructions C3 ADAPTING BLOWER FOR RECIRCULATION NOTE: The exhaust adaptor with damper is not needed for recirculating models. You may want to save them for possible future use. 1 Carefully pull out the blower unit. The wires will extend far enough to allow you to adjust the blower unit. Blower Plate Blower Motor Screw 2 Carefully pull out the blower unit. The wires will extend far enough to allow you to adjust the blower unit. BEFORE: Fan Blade 2SHQLQJV)DFLQJ8S End B 4 Place the blower unit back into the opening. WARNING:5LVNRIHOHFWULFVKRFN can cause injury or death. Do not pull or stretch WKHEORZHUXQLWZLULQJ0DNHVXUHWKHZLUHGDUH not pinched. 5 Close the blower plate. Secure with the screw removed earlier. Blower Plate Back of Oven Screw End A 3 Roll the blower unit 90° so that fan blade openings are facing out the back of the oven. AFTER: Fan Blade 2SHQLQJV)DFLQJ Forward Back of Oven Back of Oven NOTE: Make sure wires remain routed in the grooves of the motor frame. 20

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
Place the blower unit back into the opening.
WARNING:
can cause injury or death.
Do not pull or stretch
not pinched.
5
4
AFTER: Fan Blade
Forward
ADAPTING BLOWER
FOR RECIRCULATION
C3
20
NOTE:
The exhaust adaptor with damper is not
needed for recirculating models. You may want
to save them for possible future use.
Carefully pull out the blower unit. The wires
will extend far enough to allow you to adjust
the blower unit.
NOTE:
Make sure wires remain routed in the grooves
of the motor frame.
Installation Instructions
1
Blower Plate
Blower
Motor Screw
BEFORE: Fan Blade
2
End B
End A
Carefully pull out the blower unit. The wires
will extend far enough to allow you to adjust
the blower unit.
Roll the blower unit 90° so that fan blade openings
are facing out the back of the oven.
3
Back of
Oven
Back of
Oven
Blower Plate
Back of
Oven
Screw
Close the blower plate. Secure with the screw
removed earlier.