GE PNM9196SFSS Installation Instructions - Page 16
Adapting Blower For, For Preparation Of Top, Cabinet - motors
View all GE PNM9196SFSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Installation Instructions 7RXVHWRJJOHEROWV Mounting Plate Spacing for Toggles More Than Wall Thickness Toggle Wings Toggle Bolt Wall Bolt End 3 Place the mounting plate against the wall and insert the toggle wings into the holes in the wall to mount the plate. NOTE: Before tightening toggle bolts and wood screw, make sure the tabs on the mounting plate touch the bottom of the cabinet when pushed flush against the wall and that the plate is properly centered under the cabinet. CAUTION:%HFDUHIXOWRDYRLGSLQFKLQJ ILQJHUVEHWZHHQWKHEDFNRIWKHPRXQWLQJ plate and the wall. 4 Tighten all bolts. Pull the plate away from the wall to help tighten the bolts. B4 ADAPTING BLOWER FOR 2876 867 1 Remove the blower motor screw that holds the blower plate to the oven. Lift the front of the blower plate to install the blower. Blower Motor Screw Blower Plate Blower Motor Screw 2 Carefully pull out the blower unit. The wires will extend far enough to allow you to adjust the blower unit. BEFORE: Fan Blade 2SHQLQJV)DFLQJ8S End B End A B3 86(723&$%,1(77(03/$7( FOR PREPARATION OF TOP CABINET You need to drill holes for the top support screws and a hole large enough for the power cord to fit through. 3 Rotate blower unit counterclockwise 180°. Before Rotation After Rotation Back of Oven Back of Oven 4 Gently remove the wires from the grooves. Reroute the wires through grooves on other side of the blower unit. Before Rerouting After Rerouting Read the instructions on the TOP CABINET TEMPLATE. Tape it underneath the top cabinet. Drill the holes, following the instructions on the TOP CABINET TEMPLATE. CAUTION::HDUVDIHW\JRJJOHVZKHQ GULOOLQJKROHVLQWKHFDELQHWERWWRP Wires Routed Through Right Side Wires Routed Through Left Side 16