GE PNM9196SFSS Installation Instructions - Page 19

Installation Instructions C RECIRCULATING 1RQ9HQWHG'XFWOHVV ,167$//$7,2129(59,(: C1. Attach Mounting Plate to Wall C2. Prepare Top Cabinet C3. Adjust Blower C4. Mount the Oven C5. Install Charcoal Filter (Supplied with JNM1951, DVM1950 and PNM1971 models) C1 ATTACH THE MOUNTING PLATE TO THE WALL 3 Place the mounting plate against the wall and insert the toggle wings into the holes in the wall to mount the plate. NOTE: Before tightening toggle bolts and wood screw, make sure the tabs on the mounting plate touch the bottom of the cabinet when pushed flush against the wall and that the plate is properly centered under the cabinet. Attach the plate to the wall using toggle bolts. At least one wood screw must be used to attach the plate to a wall stud. 1 Remove the toggle wings from the bolts. 2 Insert the bolts into the mounting plate through the holes designated to go into drywall and reattach the toggle wings to 3ø4s onto each bolt. CAUTION:%HFDUHIXOWRDYRLGSLQFKLQJ ILQJHUVEHWZHHQWKHEDFNRIWKHPRXQWLQJSODWHDQG the wall. 4 Tighten all bolts. Pull the plate away from the wall to help tighten the bolts. C2 86(723&$%,1(77(03/$7( FOR PREPARATION OF TOP CABINET You need to drill holes for the top support screws and a hole large enough for the power cord to fit through. 7RXVHWRJJOHEROWV: Mounting Plate Spacing for Toggles More Than Wall Thickness Toggle Wings Toggle Bolt Wall Bolt End ‡ Read the instructions on the TOP CABINET TEMPLATE. ‡ Tape it underneath the top cabinet. ‡ Drill the holes, following the instructions on the TOP CABINET TEMPLATE. CAUTION::HDUVDIHW\JRJJOHVZKHQ GULOOLQJKROHVLQWKHFDELQHWERWWRP 19