Gigabyte B650I AORUS ULTRA User Manual - Page 24

42 _3 M2C_SB (Note 4) 60A 80 w M2C_SB: Step 1: Unfasten the 5 screws of the motherboard backplate to remove the backplate. Insert the M.2 SSD into the M.2 connector at an angle. Press the M.2 SSD down and then secure it with the screw. Step 2: Remove the protective film from the M.2 SSD thermal pad on the motherboard backplate and screw the backplate back on. If you want to install an M.2 SSD in the M2C_SB connector, be sure to install a system cooling fan and provide heat dissipation to the motherboard backplate to achieve optimum system stability. U * Types of M.2 SSDs supported by the M.2 connector: M.2 PCIe x4 SSD M.2 PCIe x2 SSD M2B_CPU a a M2A_CPU a a M2C_SB a a M.2 SATA SSD r r r 9) SATA3 0/1/2/3 (Note 1) (SATA 6Gb/s Connectors) The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA 1.5Gb/s standard. Each SATA connector supports a single SATA device. The SATA connectors support RAID 0, RAID 1, and RAID 10. Please navigate to the "Configuring a RAID Set" page of GIGABYTE's website for instructions on configuring a RAID array. 1 1 SATA3 1 0 23 Pin No. Definition 7 1 GND 2 TXP 3 TXN 7 4 GND 5 RXN 6 RXP 7 GND _0 F _0 _F F _SB To enable hot-plugging for the SATA ports, please navigate to the "BIOS Setup" page of GIGABYTE's website and search for "SATA Configuration" for more information. (Note 1) The connector is on the front of GC-B650I FRONT CARD. (Note 4) The connector is on the back of the motherboard. - 24 - _S