Gigabyte B650I AORUS ULTRA User Manual - Page 25

10) F_PANEL (Note 1) (Front Panel Header) Connect one end of the front panel extension cable to this header and connect the power switch, reset switch, speaker, chassis intrusion switch/sensor and system status indicator on the chassis front panel to the other end. Note the positive and negative pins before connecting the cables. Note the positive and negative pins before connecting the cables. +' 5(6 &, 3:5B/(' Power LED Power Switch Speaker PLED+ PLED- PW+ PWSPEAK+ NC NC SPEAK- 2 20 1 19 HD+ HD- RESRES+ CICI+ PWR_LED+ PWR_LEDPWR_LED- Front panel extension cable F_PANEL Hard Drive Reset Activity LED Switch Power LED Chassis Intrusion Header •• PLED/PWR_LED (Power LED): System Status LED Connects to the power status indicator on the chassis front panel. The LED S0 On S3/S4/S5 Off is on when the system is operating. The LED is off when the system is in S3/ S4 sleep state or powered off (S5). •• PW (Power Switch): Connects to the power switch on the chassis front panel. You may configure the way to turn off your system using the power switch (please navigate to the "BIOS Setup" page of GIGABYTE's website and search for "Soft-Off by PWR-BTTN" for more information). •• SPEAK (Speaker): Connects to the speaker on the chassis front panel. The system reports system startup status by issuing a beep code. One single short beep will be heard if no problem is detected at system startup. •• HD (Hard Drive Activity LED): Connects to the hard drive activity LED on the chassis front panel. The LED is on when the hard drive is reading or writing data. •• RES (Reset Switch): Connects to the reset switch on the chassis front panel. Press the reset switch to restart the computer if the computer freezes and fails to perform a normal restart. •• CI (Chassis Intrusion Header): Connects to the chassis intrusion switch/sensor on the chassis that can detect if the chassis cover has been removed. This function requires a chassis with a chassis intrusion switch/sensor. •• NC: No connection. (Note 1) The connector is on the front of GC-B650I FRONT CARD. The front panel design may differ by chassis. A front panel module mainly consists of power switch, reset switch, power LED, hard drive activity LED, speaker and etc. When connecting your chassis front panel module to this header, make sure the wire assignments and the pin assignments are matched correctly. - 25 -