Gigabyte GA-78LMT-USB3 Manual - Page 25

2-3 MB Intelligent Tweaker(M.I.T.) CMOS Setup Utility-Copyright (C) 1984-2012 Award Software MB Intelligent Tweaker(M.I.T.) ` IGX Configuration CPU Clock Ratio CPU NorthBridge Freq. Core Performance Boost (Note) CPB Ratio (Note) Turbo CPB (Note) CPU Host Clock Control x CPU Frequency(MHz) PCIE Clock(MHz) HT Link Width HT Link Frequency Set Memory Clock x Memory Clock ` DRAM Configuration ******** System Voltage Optimized ******** System Voltage Control x NorthBridge Volt Control x DDR3 Voltage x CPU Voltage Control x CPU NB VID Control Normal CPU Vcore Normal CPU Vcore NB [Press Enter] [Auto] 2800Mhz [Auto] 2000Mhz [Enabled] [Auto] 3100Mhz [Disabled] [Auto] 200 [Auto] [Auto] [Auto] 2000Mhz [Auto] x6.66 1333Mhz [Press Enter] [Auto] Auto Auto Auto Auto 1.3250V 1.2000V Item Help Menu Level  Move Enter: Select F5: Previous Values +/-/PU/PD: Value F10: Save F6: Fail-Safe Defaults ESC: Exit F1: General Help F7: Optimized Defaults Whether the system will work stably with the overclock/overvoltage settings you made is dependent on your overall system configurations. Incorrectly doing overclock/overvoltage may result in damage to CPU, chipset, or memory and reduce the useful life of these components. This page is for advanced users only and we recommend you not to alter the default settings to prevent system instability or other unexpected results. (Inadequately altering the settings may result in system's failure to boot. If this occurs, clear the CMOS values and reset the board to default values.) && IGX Configuration CMOS Setup Utility-Copyright (C) 1984-2012 Award Software IGX Configuration Internal Graphics Mode UMA Frame Buffer Size x Surround View Onboard VGA output connect VGA Core Clock control x VGA Core Clock(MHz) [UMA] [Auto] Disabled [Auto] [Auto] 350 Item Help Menu Level  Move Enter: Select F5: Previous Values +/-/PU/PD: Value F10: Save F6: Fail-Safe Defaults ESC: Exit F1: General Help F7: Optimized Defaults && Internal Graphics Mode Allows you to determine whether to allocate system memory for the onboard graphics controller. Disabled Disables the onboard graphics controller. UMA Allocates memory for the onboard graphics controller from the system memory. (Default) && UMA Frame Buffer Size Frame buffer size is the total amount of system memory allocated solely for the onboard graphics controller. MS-DOS, for example, will use only this memory for display. Options are: Auto (default), 128MB, 256MB, 512MB, 1024MB. (Note) This item is present only when you install a CPU that supports this feature. - 25 -