Gigabyte GA-E7AUM-DS2H Manual - Page 87
B. Installing Windows Vista
View all Gigabyte GA-E7AUM-DS2H manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 87 highlights
B. Installing Windows Vista (The procedure below assumes that only one RAID array exists in your system.) Step 1: Restart your system to boot from the Windows Vista setup disk and perform standard OS installation steps. When a screen similar to that below appears (RAID hard drive(s) will not be detected at this stage), select Load Driver. (Figure 7). Figure 7 Step 2: Specify the location where the driver is saved, such as your floppy disk or USB flash drive (Figure 8). Figure 8 - 87 - Appendix
Appendix
- 87 -
B. Installing Windows Vista
(The procedure below assumes that only one RAID array exists in your system.)
Step 1:
Restart your system to boot from the Windows Vista setup disk and perform standard OS installation
steps. When a screen similar to that below appears (RAID hard drive(s) will not be detected at this
stage), select
Load Driver
. (Figure 7).
Figure 7
Figure 8
Step 2:
Specify the location where the driver is saved, such as your floppy disk or USB flash drive (Figure 8).