Haier HBU-14HC03 User Manual - Page 24
Installation Procedures
View all Haier HBU-14HC03 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Installation Procedures 1. Remove upper part of wire controller Remove upper part of wire controller by press. PCB is mounted on lower part of wire controller, be careful not to damage it. Upper part of wire controller Lower part of wire controller 2. Install wire controller (1) For exposed installation, use 2 wood screws (accessory). (2) For recessed installation, use 2 wood screws (accessory). 3.The dial code is set as: 1. ON 2.OFF 3.ON 4.OFF Note: Try as far as possible a flat surface for installation. Don't use excessi force when tightening screws, or lower part might got deformed. 22
22
3.The dial code is set as:
1. ON 2.OFF 3.ON 4.OFF
1. Remove upper part of wire controller
Remove upper part of wire controller by press.
2. Install wire controller
(1) For exposed installation,
use 2 wood screws (accessory).
(2) For recessed installation,
use 2 wood screws (accessory).
Note:
Try as far as possible a flat surface for installation. Don't use excessi
force when tightening screws, or lower part might got deformed.
PCB is mounted on lower part of wire controller, be careful not to
damage it.
Lower part of wire
controller
Upper part of wire
controller
Installation Procedures