Haier HWM5TL User Manual - Page 10
recommended
View all Haier HWM5TL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
English The machine beeps and display shows error codes: E0 - This code is displayed when the washer door is not shut properly during the delay start mode. Close the washer door properly to continue. El - This code is displayed when the draining is too slow. The hose could be blocked, or not properly set. Arrange the hose properly in order to drain. E2 - This code is displayed when the washer stops running during the Wash -3.-Spin -s-Rinse mode. The washer door is not closed properly. Close the top washer door properly to continue. E3 - This code is displayed when the washer does not spin. This is due to the washer not being leveled properly or the tub being overloaded. Adjust the leveling legs to balance the washer. Take out some clothes and rearrange clothes inside the tub. E4 - This code is displayed when the machine stops running after 15 minutes because the incoming water flow is very slow. This is due to not having the faucet open properly. Open the water faucet properly to increase the incoming water flow. Problems with water: • Not enough water coming out: Water faucet may need to be turned on fully. Water hoses may be tangled up or wrinkled up. Straighten up hoses. Check water level selection, it may need to be readjusted. • Water leaks: This is due to not installing the drain hose or fill hoses properly. Your home drain may be clogged or having constant water pressure. You may need to tighten hoses, check the plumbing or call a plumber. • Water will not drain: This is due to not installing your drain hose properly. You may need to arrange the drain hose properly. Check the position of the drain hose. • There may be some water flowing out of the drain hose in the first use of the • machine. This is due to the remaining water left in the tub at the factory, to inspect and test the performance of the unit. 19 Warning: • Never pour fabric softener directly onto clothes because ii will stain your clothes or you may get some spots on your clothes. • Use only a liquid form of softener in the dispenser. Do not use a powder form of softener in the dispenser. Cleaning the Dispenser: • Clean fabric softener dispenser after each use. • Fill dispenser with clean water in wash cycles when not using softener. This will prevent residue from building up on, or in the dispenser. Proper Use of Detergent: The amount of detergent to use depends on size of load, water type (hard or soft) and whether the clothes are heavily soiled or lightly soiled. Besides the performance of the washing machine the quality of the detergent also affects the washing result. Detergent Dispenser It is located on the mid-back of the control panel. detergent dispenser Note: Add the concentrated composite washing powder into the box directly as indicated in the above left figure. Proper Use of Bleach: Use the manufacturer's chart for recommended use of liquid or powder bleach by looking on the container. Warning: Be careful not to spill undiluted bleach on the washer cabinet or your clothes as it is a strong chemical. It may damage some of your clothes or the finish of the washer if not properly diluted. Bleach Dispenser It is located on the top left front corner of the washer under the top lid. Note: Use only liquid bleach in the dispenser. You can use powder bleach by directly adding to wash tub. bleach dispenser 8