Harman Kardon AVR20 Owners Manual - Page 6

10 VCR 1 DUBBING BUTTON Press the VCR 2 button and VCR1 DUBBING button. Set the recording VCR (VCR 1) to recording mode. Set the playback VCR (VCR 2) to playback mode. Dubbing will start. El To hear another input source during video tape dubbing: Press the input function you want to hear, and play the input source. NOTE: If you press the TEST TONE button during VCR 1 DUBBING, the audio signal is not recorded. 11 PRESET SCAN BUTTON Press this button to scan the preset station frequencies. The receiver stops at each preset location that contains a frequency for about 4 seconds, so you can hear a station. The preset location indicator blinks 4 times. Press this button again to stop scanning. 12 SEARCH SELECTOR Press this button to select AUTO or MANUAL tuning. III In AUTO mode, scanning is automatically continued up or down until the next station is picked up by pressing the UP/DOWN tuning button. The display window shows 'SEARCH'. Use this mode to quickly find strong AM or FM stations. • In MANUAL mode, the frequency is changed by a step with the UP/DOWN button. If you keep pressing the UP/DOWN tuning button, scanning is continued until the button is released. NOTE: Tuning Intervals: BAND USA/CANADA EUROPE/AUSTRALIA FM 50 KHz 50 KHz AM 10 KHz 9 KHz 13 FM MODE BUTTON Press this button to select stereo or mono mode. ■ STEREO: Provides stereophonic reception of an FM stereo broadcast. The display window shows 'STEREO'. ■ MONO: The left and right channel signals detected from an FM stereo broadcast are mixed and reproduced through both channels. If you want to find a weak FM station, select this mode. The display window shows 'MONO'. 14 STATION MEMORY BUTTON Use this button to store an AM or FM frequency. Press this button and select one of 30 preset locations to store the frequency with the STATION PRESET buttons while the memory indicator, 'MEMORY' blinks. NOTE: When you store a frequency in a memory location that already contains a frequency, you replace the previous frequency. If your receiver is disconnected from AC power for more than about 10 days, it loses all stored frequencies. 15 UP/DOWN TUNING BUTTONS Press the DOWN button ( v ) to tune in lower frequency stations, the UP button ( A ) to tune in higher frequency stations. If you press the DOWN button when the display is at the bottom of the frequency range, the display returns to the top of the range. If you press the UP button when the display is at the top of the frequency range, the display returns to the bottom of the range. When the receiver finds a strong frequency, the display window shows 'TUNED'. 16 FM/AM BAND SELECTOR Press these buttons to select the FM or AM radio band. When you select the AM or FM radio band, the receiver displays the last frequency selected on that band. 17 STATION PRESET BUTTONS Select one of 30 preset locations to recall the station stored in memory. The input function is automatically changed to TUNER when the button is pressed. When you select numbers from 10 through 29, you must select the second digit within about 2 seconds. To select preset 30, simply press "0". 5