HealthRider H 300 Treadmill English Manual - Page 8

4. Hold the Console Base (47) near the Left Handrail (71). 4 Attach the ends of the ground wires on the Console Base to the indicated small hole in the Left Handrail with the Silver Ground Screw (75). Ground Wires 47 Small Hole 75 71 5. Touch the Right Handrail (72) to discharge any static. Slide the sleeve off the connector as shown in the inset 5 drawing. Press the end of the Upright Wire (42) into the socket in the bottom of the Console Base (47). The con- nector should slide easily into the socket and snap into place. If the connector does not slide easily and snap into place, turn the connector and then insert it. Slide the 72 sleeve back over the connector. 42 47 Sleeve Connector 42 6. Set the Console Base (47) on the Right Handrail (72) and the Left Handrail (71). Attach the Console Base with four 3/4" Screws (2). Start all four Screws before tightening them; do not overtighten the Screws. See the lower drawing. Make sure that the Upright Wire (42) is routed below the two indicated round posts (A). Next, press the Upright Wire into the slot between the square post (B) and the Console Base (47). 6 72 2 47 71 2 A B 42 47 8