HealthRider Hotel Fitness Tr9700 Treadmill English Manual - Page 23
How To Lubricate The Walking Belt
View all HealthRider Hotel Fitness Tr9700 Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
3. Using a hand-held vacuum, clean the area under the Motor Hood (not shown). Be careful to avoid touching any components. Check the Drive Motor Belt (72) for wear and cracks. If the Drive Belt needs to be replaced, please see the back cover of this manual. 3 72 4. Plug in the power cord and insert the key into the console. Press the Start/Stop button. IMPORTANT: Be careful to avoid injury; keep your hands away from moving parts and make sure that your clothes cannot become caught in moving parts. While the walking belt is moving, check the treadmill for unusual noises or odors. If any of these problems exist, please see the back cover of this manual. Remove the key and unplug the power cord. See steps 1 and 2. Reattach the Motor Hood (66) with the six #8 x 3/4" Screws (7). REPLACING THE WALKING BELT Regularly inspect the walking belt. When the walking belt becomes worn, it should be replaced. Please see the back cover of this manual to order a new walking belt. REPLACING THE WALKING PLATFORM Regularly inspect the walking platform. When the walking platform becomes worn, the walking platform should be replaced. Please see the back cover of this manual to order a new walking platform. HOW TO LUBRICATE THE WALKING BELT Regularly inspect the walking belt. When the walking belt does not slide easily over the walking platform, the walking belt should be lubricated. Please see the back cover of this manual to order lubricant. To lubricate the walking belt, remove the key from the console and unplug the power cord. Pull the left and right edges of the walking belt toward the idler roller, until the seam of the walking belt is above the idler roller. Avoid pinching your fingers. Open one tube of belt lubricant. Lift the right edge of the walking belt. Apply one half of the lubricant to the walking platform in a zigzag pattern as shown. Apply the lubricant as close to the center of the walking platform as possible, but leave an unlubricated strip about 2 in. (5 cm) wide beneath the right edge of the walking belt. Lift the left edge of the walking belt and apply the other half of the lubricant in the same way. Then, firmly rub the top of the walking belt to transfer the lubricant from the walking platform to the walking belt. Seam Pull the edges of the walking belt toward the idler roller, until the seam of the walking belt is above the drive roller. Repeat the steps above with a second tube of lubricant. 23